MIL-PRF-46103E
STANDARDS
DEPARTMENT OF DEFENSE
MIL-STD-662
- V50 Ballistic Test For Armor
MIL-STD-810
- Environmental Test Methods And Engineering Guidelines
(Unless otherwise indicated, copies of the above specifications, standards, and
handbooks are available from the Standardization Document Order Desk, 700
Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094).
2.3 Non-Government publications. The following documents form a part of this
document to the extent specified herein. Unless otherwise specified, the issues
of the documents which are DoD adopted are those listed in the issue of the
DoDISS cited in the solicitation. Unless otherwise specified, the issues of
documents not listed in the DoDISS are the issues of the documents cited in the
solicitation (see 6.2).
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM D792
- Density and Specific Gravity (Relative Density) of Plastics
by Displacement
(Application for copies should be addressed to the American Society for Testing
and Materials, 100 Barr Harbor Drive, West Conshohocken, PA 19428).
2.4 Order of precedence. In the event of a conflict between the text of this
document and the references cited herein, the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
3.
REQUIREMENTS
3.1 First article. When specified in the contract or purchase order, a sample
shall be subjected to first article inspection (see 4.2.1 and 6.2).
3.2 Materials. Unless otherwise specified (see 6.2), the materials are the
prerogative of the contractor as long as all the operating, environmental and
identification marking requirements are fully met.
3.3 Construction. The contractor shall select the methodology of construction
provided these methods are capable of yielding uniform properties in the
completed structure and that all structural interfaces have no unbounded areas.
3.3.1 Molding. If the process of molding is used then the material shall be
molded into the required configuration without breaking or damaging the
material. Such procedures and methods shall be capable of yielding uniform
properties in the completed structure.
3.3.2 Spall cover and edge strip. If a spall cover is used then the spall cover
shall be of such a configuration as to cover the entire outer surface. The edge
strip shall be cut to go around the entire periphery of the composite armor and
extend beyond the inner edges 0.50-0.75 inches (12.7-19.0 mm). The edges shall
not fray before application to the composite armor.
3.3.3 Assembly of components by bonding. All components required to be
assembled by bonding shall be thoroughly cleaned of all foreign matter.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business